Leaf Rust of Wheat
Note Number: AG1351
Published: June 2008
Updated: July 2012
Rusts are the most important foliar diseases of wheat in Australia. Compared to stripe and stem rust, leaf rust is potentially the least damaging in susceptible varieties, but in most seasons conditions are conducive for this disease. In most parts of Victoria leaf rust is effectively controlled with resistant varieties, but it can cause problems in areas where susceptible varieties are grown.
What to look for
|
Fig 1. Leaf rust symptoms |
Economic importance
In Victoria, severe leaf rust infections can reduce grain yield by more than 20 per cent in susceptible varieties, and can also reduce grain quality. In recent years losses from leaf rust have been confined to districts where susceptible varieties were grown.
Disease cycles
cereal rusts, requires a living host to survive from one season to the next. The most important host for rusts are susceptible volunteer wheat plants growing during the summer/autumn. Rust cannot carry over from one season to the next on seed, stubble or in soil. Leaf rust is caused by the fungus Puccinia triticina. Leaf rust, like other Wheat varieties susceptible to leaf rust enable inoculum levels to build up on volunteers during the summer and autumn. This can be a problem in seasons following wet summers that favour the growth of self-sown wheat. The plants that become heavily infected with rust in the autumn provide a source of rust for the new season’s wheat crop. If these conditions are followed by a mild winter and a warm wet spring, then the chances of a leaf rust epidemic are high. Therefore, the chances of a rust epidemic are greatest following a wet summer.
In Australia, due to the absence of the alternate host, leaf rust reproduces asexually. This reduces the variability of the rusts in the field and therefore increases the likelihood that resistant varieties will be effective for a long period of time.
Rust spores are wind-blown and can be spread over large areas in a short time. The establishment of leaf rust epidemics within a crop is favoured by wet conditions and temperatures of approximately 15-22°C.
Management
Resistant varieties
The best way to control leaf rust is to grow resistant varieties. In most parts of Victoria leaf rust has been effectively controlled because of the widespread use of wheat varieties with resistance to this disease.
However, leaf rust occasionally produces new races which are capable of attacking varieties that were resistant when they were first released. These new races occur when a chance mutation occurs in this asexually reproducing fungus. Widespread cultivation of resistant varieties minimises the levels of rust in the environment and reduces the occurrence of new races.
It is important that growers are aware of their varieties’ disease reaction to leaf rust. Variety resistance ratings are available in the Cereal Disease Guide (AG1160). It is important to use a current disease guide as mutations occur in rust from time to time, and resistant ratings are adjusted accordingly.
Cultural practices
Heavy grazing or the use of herbicides during autumn to remove self-sown susceptible wheat will reduce the amount of rust in following crops. However, if spring conditions are favourable for leaf rust development, then even small amounts of rust that survived the autumn can multiply to cause serious yield losses in the spring.
Seed treatments
There are seed treatments available which will suppress early infections of leaf rust. Seed treatments are important in susceptible varieties, especially if they are sown early or following a wet summer favouring growth of volunteers.
Foliar fungicides
There are a number of foliar fungicides registered for the control of leaf rust in wheat. Fungicides should not be regarded as a substitute for growing resistant varieties. They are more of a back up for when a new race of rust evolves and for use in regions where adequate resistance is not available.
A fungicide response is unlikely in resistant or moderately resistant varieties.
The earlier in a season that a rust epidemic starts, then the greater the potential yield loss. Crops need to be monitored to detect rust early, as timing is critical for the effective control of rust diseases with fungicides. Rust epidemics can be explosive, and once out of control, can be difficult to contain.
Like the other rusts it is important to apply fungicides early in the epidemic. If a severe epidemic develops early in the season in a susceptible variety, then it may be necessary to make two applications of fungicide. Rust first appearing after ear emergence is less likely to have a significant impact on grain yield.
Further References
More detailed information can be obtained from the DPI Information Note Series: www.dpi.vic.gov.au/graindiseases
Cereal Diseases Guide (AG1160)
Victorian Winter Crop Summary
Wallwork H (2000) Cereal Leaf and Stem Diseases.
For rust identification, send rusted plant samples in a paper envelope (do not use plastic wrapping) to: Australian Cereal Rust Survey. Plant Breeding Institute. Private Bag 4011, Narellan NSW 2567
Contact/Services available from DPI
DPI Field Crop Pathology, Grains Innovation Park,110 Natimuk Rd, Horsham 3400. Tel (03) 5362 2111, or the DPI Customer Service Centre 136 186.
Acknowledgements
This Information Note (AG1351) was developed by Grant Hollaway in June 2009. It was reviewed by Frank Henry, Farm Services Victoria. Financial support by the GRDC is gratefully acknowledged. Last Updated: July 2012.

ISSN 1329-8062
Published and Authorised by:
Department of Environment and Primary Industries
1 Spring Street
Melbourne, Victoria
This publication is copyright. No part may be reproduced by any process except in accordance with the provisions of the Copyright Act 1968.
The advice provided in this publication is intended as a source of information only. Always read the label before using any of the products mentioned. The State of Victoria and its employees do not guarantee that the publication is without flaw of any kind or is wholly appropriate for your particular purposes and therefore disclaims all liability for any error, loss or other consequence which may arise from you relying on any information in this publication


